Other Transmission Features
122
2
D Enter the time using the number keys and select [AM] or [PM]. Then press [OK].
When entering numbers smaller than 10, add a zero at the beginning.
If you make a mistake, press [Clear] or the {Clear/Stop} key before pressing
[OK], and then try again.
To cancel Send Later, press [Cancel]. The display returns to that of step
C
.
The specified time is shown above the highlighted [Send Later].
E Press [OK].
The standby display appears.
To check the settings, press [TX Mode].
F Specify a destination, and then press the {Start} key.
Note
❒ You can specify a time within 24 hours of the current time.
❒ If the current time shown is not correct, change it.
❒ You can program one of the Quick Operation keys with operations for this
function. Using the Quick Operation key allows you to omit step
B
.
❒ You can cancel the transmission setup for Send Later. See “Canceling a
Transmission”.
Reference
p.112 “Canceling a Transmission”
“System Settings”, General Settings Guide
“Facsimile Features”, General Settings Guide
“Troubleshooting When Using the Facsimile Function”, Troubleshooting
To Next Page
Loading...
Need help?
General
