Messages Displayed When Using the Printer Function
57
4
Messages Printed on the Error Logs or Reports
This section describes likely causes of and possible solutions for the error mes-
sages that are printed on the error logs or reports.
Message Cause Solution
84: Error
There is no work area
available for image
processing.
•In [Printer Features], under [Sys-
tem], set [Memory Usage] to [Font
Priority].
• Decrease the number of files sent
to the machine.
85: Error
The specified graphics li-
brary is unavailable.
Check that the data is valid.
86: Error
Parameters of the control
code are invalid.
Set the parameters correctly.
Address Book is
currently in use
by another func-
tion. Authentica-
tion has failed.
The machine currently
cannot perform authenti-
cation because the address
book is being used by an-
other function.
Wait a while, and then retry the op-
eration.
Auto-registration
of user informa-
tion has failed.
Automatic registration of
information for LDAP Au-
thentication or Windows
Authentication failed be-
cause the address book is
full.
Contact the administrator.
Cannot store data
of this size.
The paper size exceeded
the capacity of the docu-
ment server.
Reduce the paper size of the file that
you want to send to a size that the
document server can store. Custom
size files can be sent but not stored
afterward.
Collate has been
cancelled.
Collate was canceled. Turn the main power switch off and
then back on again. If the message
appears again, contact your sales or
service representative.
Command Error
An RPCS command error
occurred.
Check using the following proce-
dure:
• Check if the communication be-
tween the computer and the ma-
chine is working correctly.
• Check if the correct printer driver
is being used.
• Check if the machine's memory
size is set correctly in the printer
driver.
• Check that the printer driver is
the most up-to-date version
available.
To Next Page
Loading...
