13
C Set the paper size using the printer driver or the control panel.
The following procedures are not required if you select [Driver / Command]
from [Bypass Tray Setting Priority] in [System] of [Printer Features]. In that case,
set the paper size using the printer driver.
Note
❒ Paper sizes that can be loaded onto the bypass tray are 90 - 305 mm (3.6” -
12”) vertical, and 148 - 600 mm (5.9” - 23.7”) horizontal.
❒ When loading OHP transparencies or thick paper, set paper size and paper
type.
❒ The number of sheets that can be loaded in the bypass tray depends on the
paper type.
Reference
When loading letterhead paper, pay attention to its orientation. See Gener-
al Settings Guide.
For printer driver settings, see the printer driver Help.
To Next Page
Loading...
