Message Causes Solutions
"Output tray has been
changed."
The output tray was
changed because the paper
size of the specified output
tray is limited.
Specify the proper output tray.
"Print overrun." Images were discarded
while printing.
PCL 6
Select a lower resolution on the
printer driver. For details about
how to change the resolution
setting, see the printer driver Help.
PostScript 3
Select a lower resolution on the
printer driver. For details about
how to change the resolution
setting, see the printer driver Help.
"Printing privileges have not
been set for this document."
The PDF document you
have tried to print has no
privileges to print.
Contact the owner of the document.
"Punch has been
cancelled."
Punch printing was
canceled.
Check the paper orientation, print
orientation, and then punch position.
Certain settings can produce print results
that might not be as expected.
"Receiving data failed." Data reception was
aborted.
Resend the data.
"Selected ppr. size is not
supported. Job was
cancelled."
Job reset is automatically
performed if the specified
paper size is incorrect.
Specify the correct paper size, and then
print the file again.
"Sending data failed." The machine received a
command to stop
transmission from the printer
driver.
Check if the computer is working
correctly.
"Staple has been
cancelled."
Stapling printing was
canceled.
Check the paper orientation, paper
quantity, print orientation, and staple
position. Certain settings can produce
print results that might not be as
expected.
When Messages Are Displayed on the Control Panel
209
To Next Page
Loading...
Need help?
General
