Message Causes Solutions
"Connection with LDAP
server has failed. Check the
server status."
A network error has
occurred and connection
has failed. Try the operation
once more.
• Try the operation again. If the
message is still shown, the
network may be busy.
• Check that the correct settings for
LDAP server are listed in
[Administrator Tools] of [System
Settings]. For details about LDAP
server, see "Programming the
LDAP server", Connecting the
Machine/ System Settings .
"Could not send the data
because the PC timed out
before it was sent."
A time out occurred when
using WSD Scanner. Time
outs occur when too much
time passes between
scanning an original and
sending its data. The
followings are likely causes
of time outs:
• Too many originals per
set.
• Misfed originals.
• Transmission of other
jobs.
• Reduce the number of originals,
and then scan again.
• Remove any misfed original, and
then scan again.
• Use Scanner Journal to check
there are no jobs awaiting
transmission, and then scan
again.
"Entered user code is not
correct. Please re-enter."
You have entered an
incorrect user code.
Check the authentication settings, and
then enter a correct user code.
"Exceeded max. E-mail size.
Sending E-mail has been
cancelled. Check [Max. E-
mail Size] in Scanner
Features."
The file size per page has
reached the maximum e-
mail size specified in
[Scanner Features].
Change the facsimile features settings
as follows:
• Increase the e-mail size limit in
[Max. E-mail Size].
• Change the [Divide & Send E-
mail] setting to [Yes (per Page)] or
[Yes (per Max. Size)]. For details
about these settings, see "Send
Settings", Scan .
10. Troubleshooting
212
To Next Page
Loading...
