Stamp
87
3
❖ Stamp Format
Specify how each of stamp is printed.
•Stamp Position
Specify where to print the stamp.
The default setting is Top Right.
•Stamp Position
You can adjust the position of the stamp within the available ranges shown
below.
Metric version:
"Top Left"…T/B: 4-407mm, L/R: 4-407mm
"Top Center"…T/B: 4-407mm, L/R: 203-203mm
"Top Right"…T/B: 4-407mm, L/R: 4-407mm
"Center Left"…T/B: 203-203mm, L/R: 4-407mm
"Center"…T/B: 203-203mm, L/R: 203-203mm
"Center Right"…T/B: 203-203mm, L/R: 4-407mm
"Bottom Left"…T/B: 4-407mm, L/R: 4-407mm
"Bottom Center"…T/B: 4-407mm, L/R: 203-203mm
"Bottom Right"…T/B: 4-407mm, L/R: 4-407mm
Inch version:
"Top Left"…T/B: 0.1"-16.0", L/R: 0.1"-16.0"
"Top Center"…T/B: 0.1"-16.0", L/R: 8.0"-8.0"
"Top Right"…T/B: 0.1"-16.0", L/R: 0.1"-16.0"
"Center Left"…T/B: 8.0"-8.0", L/R: 0.1"-16.0"
"Center"…T/B: 8.0"-8.0", L/R: 8.0"-8.0"
"Center Right"…T/B: 8.0"-8.0", L/R: 0.1"-16.0"
"Bottom Left"…T/B: 0.1"-16.0", L/R: 0.1"-16.0"
"Bottom Center"…T/B: 0.1"-16.0", L/R: 8.0"-8.0"
"Bottom Right"…T/B: 0.1"-16.0", L/R: 0.1"-16.0"
•Size
You can set the size of the stamp.
The default setting is 1X.
•Density
You can set the pattern used to print the stamp.
Normal:
The stamp is printed on the image. You cannot check which parts will overlap.
Lighter:
The image can be seen through the stamp.
Lightest:
The image appears even clearer than in the Lighter setting.
The default setting is Normal.
• Page to Stamp
You can have the stamp printed on the first page or all pages.
The default setting is All Pages.
Reference
"Preset Stamp", Copy/ Document Server Reference
To Next Page
Loading...
