Authentication and its Application
50
2
F Press [Change] for "Domain Name".
G Enter the name of the domain controller to be authenticated, and then press
[OK].
H Select the "Printer Job Authentication" level.
Limitation
❒ If Printer Controller RW-3600 is installed, you cannot specify "Printer Job
Authentication".
Note
❒ If you select [Entire], you cannot print using a printer driver or a device that
does not support authentication. To print under an environment that does
not support authentication, select [Simple (All)] or [Simple (Limitation)].
❒ If you select [Simple (Limitation)], you can specify clients for which printer
job authentication is not required. Specify [Parallel Interface: Simple], [USB:
Simple] and the clients’ IPv4 address range in which printer job authentica-
tion is not required. Specify this setting if you want to print using unau-
thenticated printer drivers or without any printer driver. Authentication is
required for printing with non-specified devices.
❒ If you select [Simple (All)] or [Simple (Limitation)], you can print even with un-
authenticated printer drivers or devices. Specify this setting if you want to
print with a printer driver or device that cannot be identified by the ma-
chine or if you do not require authentication for printing. However, note
that, because the machine does not require authentication in this case, it
may be used by unauthorized users.
To Next Page
Loading...
