6. Reload the removed paper into the tray, and then push the tray carefully into the machine
until it clicks into place.
7. Insert the plug of the power cord into the wall socket securely. Connect all the interface
cables that were removed.
8. Turn on the power.
• If jams or multi-sheet feeds occur after cleaning the friction pad, contact your sales or service
representative.
• If the optional tray 2 is installed, clean its friction pad and paper feed roller in the same way as you
did for tray 1.
Cleaning the Exposure Glass
The following procedure describes how to clean the exposure glass.
1. Lift the ARDF or ADF.
Be careful not to hold the input tray when lifting the ARDF or ADF, for the tray might be damaged.
2. Clean the parts indicated with arrows with a soft damp cloth and then wipe the same
parts with a dry cloth to remove any remaining moisture.
To Next Page
Loading...
