Programs supplied on CD
2.
1
2 Programs supplied on
CD
The CD-ROM supplied with your printer card provides you with:
•
SetIP
: A utility program allowing you to select a network
printer card and manually configure the addresses for use
with the TCP/IP protocol.
System requirements
To install SetIP, the following are required:
• Operating system: Windows 2000/XP/2003
• Computer/Processor: 133 MHz or faster Pentium-compatible
processor
• Memory: 256 MB (recommended)
• Hard Disk space: 2 GB hard disk with 1.5 GB available hard-
disk space
• Internet Explorer 5.5 or later, or Mozilla 1.0
Installing software
1
Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM will automatically run. If it does not, click
Start
Æ
Run
, enter
x:/cdsetup.exe
(
x
represents your
CD-ROM drive), and click
OK
.
2
Select the language you want.
3
Click
Install SetIP
.
4
Follow the onscreen instructions to complete installation.
5
Click
Finish
when installation is done.
Uninstalling software
You should remove the Network utilities if you are upgrading
the software or if the installation fails.
NOTE
: Close all programs before uninstalling software.
1
Click
Start
Æ
Programs
Æ
Network Utilities
Æ
SetIP
Æ
Uninstall SetIP
.
2
Click
OK
to confirm uninstallation.
3
Click
Finish
when uninstallation is done.
To Next Page
Loading...
