Adjusting the Printer
80
Adjusting Tray Registration
You can adjust the registration of each tray. The vertical adjustment is used for
all trays. Normally, you need not update the registration. But when the optional
paper feed unit or the duplex unit is installed, updating is useful in some cases.
The following procedure describes how to adjust tray 2. The same procedure ap-
plies to other trays as well.
A Press the {Menu} key.
“Menu” appears on the display.
B Press the {U} or {T} key to display “Maintenance”, and then press the
{# Enter} key.
The maintenance menu appears.
C Press the {U} or {T} key to display “Registration”, and then press the
{# Enter} key.
The registration menu appears.
D Print the test sheet to preview the settings. Confirm that “Prt. Test
Sheet” is displayed, and then press the { # Enter} key.
A screen prompting you to select the tray to be adjusted appears.
E Press the {U} or {T} key to select the tray to adjust, and then press the
{# Enter} key.
The test sheet prints out. The display returns to the registration menu. Press
the {Escape} key.
Menu:
Maintenance
Prt. Test Sheet:
Tray 2
To Next Page
Loading...
Need help?
General
