B Loading Paper
39
3
B Loading Paper
Reference
For paper types and sizes, see Gen-
eral Settings Guide.
Loading Paper
Note
You can change the paper size, see
General Settings Guide.
This illustration shows Tray 1.
A Pull the paper tray out slowly un-
til it stops.
B Push the metal plate down, and
then square the paper and load it
in the tray.
Important
Check the top of the stack is not
higher than the limit mark in-
side the tray.
If paper is left in the paper tray,
and then you add paper, a mis-
feed might occur.
Note
Fan the paper before loading.
Straighten curled or warped pa-
per before loading.
When using paper tray 2, load
paper so that the paper touches
the right side of the tray, or mis-
feeds might occur.
C Push the paper tray in, until it
stops.
ZFOY
E.eps
ZFOY
E.eps
To Next Page
Loading...
Need help?
General
