Maintaining Your Machine
53
5
Maintaining Your Machine
If the exposure glass, or ADF belt is
dirty, copy clarity may be reduced.
Clean these parts if they are dirty.
Cleaning the machine
Wipe the machine with a soft,
damp cloth. Then wipe it with a
dry cloth to remove the water.
Important
Do not use chemical cleaner or or-
ganic solvents such as thinner or
benzene. If such substances get in-
side the machine or melt plastic
parts, a failure might occur.
Do not clean parts other than those
explicitly specified in this manual.
Other parts should only be cleaned
by your service representative.
Cleaning the Exposure Glass
Cleaning the ADF
ABU037S
ABU
S.eps
ZFOH
E.eps