The [Resume] key is blinking.
(The [Power] key may be lit or blinking at the
same time.)
The duplex unit may not be installed correctly.
Install the duplex unit correctly, and then
press the [Resume] key.
Duplex Unit Not Detected .
A cover may be open.
Close the cover, and then press the [Resume]
key.
Cover Open .
Paper may be jammed.
Remove the jammed paper, and then press the
[Resume] key.
Paper Jam .
The temperature inside the printer may have
gone outside of the operating temperature
range while the power was on, or the
temperature may be outside of the operating
temperature range now.
Turn the power off, move the printer to a
location where the temperature within the
range 10-32°C (50-89.6°F), and then turn the
power on.
Out of Printable Temperature Range .
Paper of the correct size may not be loaded.
Load paper of the correct size, or change the
printer driver settings.
Paper Size Mismatch (Bypass Tray) ,
Paper Size Mismatch (Tray 1) , and Paper
Size Mismatch (Tray 2) .
The right front cover is open.
Close the right front cover.
Cover Open / Print Cartridge(s) Not
Detected .
● For details about what conditions the printer can be used under (ambient temperature and humidity range), see "Checking the Installation
Area", Setup Handbook.
Top Previous Next
Copyright © 2005 All rights reserved.
file:///E|/shared/pdf-work/newfiles/pp2w/Op_Guide/int/0143.htm (3 of 3)2005/10/05 12:05:30
To Next Page
Loading...
