Operation
12
1
Note
❒ Paper with a thickness of 35 - 127.9 g/m
2
, 9.3 - 34.0 lb can be used. Plain paper
of 52.5 - 81.5 g/m
2
, 14.0 - 21.7 lb is recommended.
❒ About 500 sheets of paper with a 75 g/m
2
, 19.9 lb thickness is the standard
amount that can be set in the paper feed tray. This amount changes depend-
ing on the paper thickness. In general, set paper at a height less than 55 mm,
2.2".
❒ Paper with a length of 90 - 275 mm, 3.6 - 10.8" and width of 140 - 395 mm, 5.5
- 15.6" can be set in the paper feed tray.
❒ The following types of paper are not recommended for this machine:
• Roughly cut paper
• Paper of different thickness and types in the same stack
• Curled or waved paper. Use paper with less than 5 mm, 0.2" curl and 3
mm, 0.1" wave.
• Grained paper loaded with the direction of the grain perpendicular to the
feed direction
❒ When paper feed problems arise, try using a slower print speed.
C2748608_Titanium3-EN.book Page 12 Wednesday, November 19, 2008 10:25 AM
To Next Page
Loading...
