Ricoh LDD745 - Adjusting the Print Image Density; Before Making a Master; After Making a Master

Adjusting the Print Image Density
21
1
Adjusting the Print Image Density
You can adjust the print image densi-
ty to suit your needs. There are two
ways to do this:
❖ Before Making a Master
Adjust the image density using the
{Image Density} key.
❖ After Making a Master
Adjust the image density using the
{Speed} key.
Before Making a Master
A Use the {Image Density} key before
pressing the {Master Making} key.
Note
❒ In addition to Normal, Darker
and Lighter modes, you can also
select Tint mode to make half-
tone prints. When the Lighter
mode indicator is blinking, Tint
mode is selected.
After Making a Master
A Press the {Speed} key to decrease
the printing speed. Press it again
to bring the printing speed back
to Fast.
Note
❒ The faster the printing speed be-
comes, the lighter the printing
density is. If you want darker
prints, decrease the printing
speed.
BQA033S
BQA034S
C2748608_Titanium3-EN.book Page 21 Wednesday, November 19, 2008 10:25 AM