Operation
16
1
Standard Printing
-Printing
In this manual, the word, “printing”
is used as opposed to “copying” in or-
der to distinguish between the pro-
cess that your machine uses to make
prints, and the process used by a stan-
dard copier machine.
A standard copier scans in the origi-
nal for each copy set made. This ma-
chine, however, scans in your original
once and makes multiple prints from
this master.
This chapter describes the basic print-
ing operations that your machine is
capable of.
A Place the original face down in
the document feeder. Adjust the
original side guides to match the
size of the original.
Note
❒ You can only place one original
at a time.
B Press the {Master Making} key.
A trial print is delivered to the pa-
per delivery tray.
C Press the {Proof} key and check
the image density and image po-
sition on the proof print.
Note
❒ If the image position is not cor-
rect, adjust it using the {Image
Position} keys. See p.19 “Adjust-
ing the Print Image Position”.
❒ If the image density is too dark
or too light, adjust the image
density using the {Image Densi-
ty} key. See p.21 “Adjusting the
Print Image Density”.
C2748608_Titanium3-EN.book Page 16 Wednesday, November 19, 2008 10:25 AM
To Next Page
Loading...
