Color Printing Using the Optional Color Drum
35
2
H Lower the drum unit lock lever.
I Close the front door.
Note
❒ Make sure that the Cover Open
indicator (M) turns off.
Printing in Two Colors
After printing in one color, you can
print in another color on the same
side of the print.
Important
❒ Allow the prints to dry for a while
before printing the second color.
❒ If the prints are still wet when you
print on them again, the paper feed
roller might become dirty. In this
case, wipe off the roller with a cloth.
Note
❒ You cannot print in two colors at a
time.
A Prepare two originals. Place the first
original in the document feeder.
B Press the {Master Making} key.
C Check the image position on the
trial or proof print.
Note
❒ If the image position is not cor-
rect, adjust it using the {Image
Position} key (see p.19 “Shifting
the Print Image Position For-
wards or Backwards”) or by
moving the position of the pa-
per (see p.20 “Shifting the Print
Image Position to the Right or
Left”).
D Enter the number of prints with
the number keys.
BQA018S
GRCOLO0E
R
P
R
P
C2748608_Titanium3-EN.book Page 35 Wednesday, November 19, 2008 10:25 AM
To Next Page
Loading...
