Combine—Combining Two Originals onto One Print
31
1
A Press the {Combine} key.
B Place the first original face down
in the document feeder.
Note
❒ The first original will be printed
on the leading part of the print.
C Specify the reproduction ratio
and check that the correct paper
size is loaded.
D Press the {Master Making} key.
E The beeper sounds after the first
original has been stored. Place the
second original face down in the
document feeder.
Note
❒ If you wish to select a different
reproduction ratio for the sec-
ond original, you need to enter
the new settings before the
beeping stops.
F Press the {Master Making} key.
G Check the image position on the
trial or proof print.
Note
❒ If the image position is not cor-
rect, adjust it using the {Image
Position} key (see p.19 “Shifting
the Print Image Position For-
wards or Backwards”) or by
moving the position of the pa-
per (see p.20 “Shifting the Print
Image Position to the Right or
Left”).
BQA037S
C2748608_Titanium3-EN.book Page 31 Wednesday, November 19, 2008 10:25 AM
To Next Page
Loading...
