Slide 34
Updating the System Firmware - 2
Preparation
Install DLP Composer Lite
Install a USB driver for the DLP device
Enter the Firmware Update Mode
» Hold the "Power" button and plug in the power cord.
» After the Power LED lights pink and Lamp/Temp LEDs light
red, release the "Power" button.
Connect the Projector to the PC
» Use a mini USB cable
Update the firmware
Use DLP Composer Lite.
» The procedure takes several minutes.
When "Download completed" appears on the screen:
» Unplug the mini USB cable and power cord.
» Plug in the power cord, then restart the projector and get into
Service mode to check the system firmware version.
To Next Page
Loading...
Need help?
General
