Adding Paper and Replacing Toner
70
6
Changing the Paper Size
This section describes how to change paper sizes.
Procedures for changing the paper size differ depending on the paper tray (Tray 1 or the option-
al paper tray unit). Make sure you are following the appropriate procedure before you begin.
Note
❒ Fan the paper before loading.
❒ Straighten curled or warped paper before loading.
Reference
For details about paper sizes and types, see “Tray Paper Settings”, General
Settings Guide.
Changing the Paper Size in the Paper Tray (Tray 1)
Use the following procedure when changing a paper size in the paper tray.
A Make sure the paper tray is not in use.
B Pull the paper tray out slowly until it stops.
C Remove any remaining copy paper.
D While pinching the release levers, pull the end fence off from the tray.
To load A4L size paper: place the end fence in the corner pocket on the left.
ARK011S
ARK012S
To Next Page
Loading...
Need help?
General