Adding Paper and Replacing Toner
72
6
H While pressing the release lever, push in the side fences until they are flush
against the paper's edges.
I While pinching the release levers, set the end fence to the new paper size.
J Push the paper tray in until it stops.
Note
❒ When setting small quantities of copy paper, be careful not to squeeze in
the side fence too much. Paper might not feed in properly if the side fences
are too tight against the paper's edges.
❒ Be sure to set the correct size, otherwise a paper jam might occur.
ARK016S
ARK017S
To Next Page
Loading...
Need help?
General