9. Adding Paper and Toner
This chapter describes how to load paper into the paper tray and recommended paper sizes and types.
Loading Paper
Precautions for Loading Paper
• When loading paper, take care not to trap or injure your fingers.
• Do not stack paper over the limit mark.
• To prevent multiple sheets from being fed at once, fan the paper before loading it.
• If you load paper when only a few sheets of paper remain in the tray, multiple sheet feeding may
occur. Remove any remaining paper, stack them with the new sheets of paper, and then fan the
entire stack before loading it into the tray.
• Straighten curled or warped paper before loading.
• For details about the paper sizes and types that can be used, see page 168 "Recommended
Paper Sizes and Types".
• You might at times hear a rustling noise from paper moving through the machine. This noise does
not indicate a malfunction.
Loading Paper into Paper Trays
Every paper tray is loaded in the same way.
In the following example procedure, paper is loaded into Tray 2.
• (mainly Europe and Asia)
Tray 1 can hold A4 paper only. If you want to print on A5 , B5 JIS , or 8
1
/
2
× 11 from Tray
1, contact your service representative.
• (mainly North America)
Tray 1 can hold 8
1
/
2
× 11 paper only. If you want to print on A4 , A5 , or B5 JIS from Tray
1, contact your service representative.
• Check the paper edges are aligned at the right side.
153
To Next Page
Loading...
Need help?
General
