Message Cause Solution
"Data Storage Error" You tried to print a Sample
Print, Locked Print, Hold
Print, or Stored Print file, or
to store a file in the
Document Server when the
hard disk was
malfunctioning.
Contact your service representative.
"Error has occurred." A syntax error, etc.,
occurred.
Check that the PDF file is valid.
"Exceeded Max. Stored
Files"
While printing a Sample
Print, Locked Print, Hold
Print, or Stored Print file, the
maximum file capacity was
exceeded.
Delete unneeded files stored on the
machine.
"Exceeded Max. Stored
Pages"
While printing a Sample
Print, Locked Print, Hold
Print, or Stored Print file, the
maximum page capacity
was exceeded.
Delete unneeded files stored on the
machine.
Reduce the number of pages to print.
"File system error. Cannot
print PDF file(s)."
PDF direct printing could not
be performed because the
file system could not be
obtained.
Turn off the power, and then back on
again. If the message appears again,
contact your service representative.
"File system is full." PDF file does not print out
because the capacity of the
file system is full.
Delete all unnecessary files from the
hard disk, or decrease the file size sent
to the machine.
"I/O buffer overflow" An input buffer overflow
occurred.
• In [Printer Features], under [Host
Interface], select [I/O Buffer],
and then set the maximum buffer
size to a larger value.
• Reduce the number of files being
sent to the machine.
9. Troubleshooting
148
To Next Page
Loading...
Need help?
General