R
Robert HendersonSep 9, 2025
What to do if Ricoh Printer says 'SSID not entered'?
- Aandrea95Sep 9, 2025
If your Ricoh Printer indicates that the SSID is not entered, enter the SSID of the wireless LAN.
To Next PageTo Next Page
What to do if Ricoh Printer says 'SSID not entered'?
If your Ricoh Printer indicates that the SSID is not entered, enter the SSID of the wireless LAN.
What to do if Ricoh shows 'Hardware Problem Printer font'?
If your Ricoh Printer displays a 'Hardware Problem Printer font' error, replace the printer font module.
What to do if Ricoh Printer shows 'Hardware Problem Parallel I/F'?
If your Ricoh Printer displays a 'Hardware Problem Parallel I/F' error, check the correct interface cable being used. Also, turn the power off, and then on.
What to do if Ricoh Printer shows 'Hardware Problem Option RAM'?
If your Ricoh Printer displays a 'Hardware Problem Option RAM' error, turn the power off, and then on. Remove and reinstall the optional RAM.
What to do if Ricoh Printer shows 'Hardware Problem HDD'?
If your Ricoh Printer displays a 'Hardware Problem HDD' error, turn the power off, and then on. Remove and reinstall the HDD board correctly.
Why is my Ricoh Printer not printing?
If your Ricoh Printer isn't printing, make sure the power cable is securely connected to both the outlet and the printer. Also, ensure paper is loaded in the tray or bypass tray. Check the interface cable connection, and if it's damaged, replace it. Verify that the port connection setting is correct and check the signal status from the [Maintenance] menu on the control panel.
Why is PDF Direct Print not working on Ricoh Printer?
If PDF Direct Print is not working on your Ricoh Printer, install an optional hard disk drive or set the value of the [RAM Disk] in the [System] menu to 2 MB or higher. Before printing, embed the font in the PDF file. When using PDF Direct Print, printout requires paper set within the PDF file.
What to do if Ricoh Printer shows 'Hardware Problem USB'?
If your Ricoh Printer displays a 'Hardware Problem USB' error, turn the power off, and then on again.
How to remove misfeed from duplex unit on Ricoh ?
To address a misfeed in the duplex unit of your Ricoh Printer, remove and reinstall the duplex unit. Also, remove any jammed paper from the duplex unit and under the rear cover.
What to do if Ricoh Printer says 'Load Paper:Tray#'?
If your Ricoh Printer displays a 'Load Paper' message, load the indicated tray with paper or select another tray using the [Form Feed] key, or cancel the job.
General