Ricoh Pro C5110S - Page 229

001 - CTL
[0 to 10 / 0 / 1/step]
0: External Controller is not installed
1: EFI, 2: Ratio, 3: Egret
4: GJ, 5:Creo, 6: QX-100
7: Kurofune
8~10: Reserved
5195
[Limitless SW]
Switches productivity precede limit less feed and use paper up limit less feed.
001 - *CTL
[0 or 1 / 0 / 1/step]
0: Productivity Precede
1: Use paper up
5196
[Copier Vendor Mode]
-
001 90 deg. Rotation CTL [- / - / - ]
002 Color and Tray Selection CTL [- / - / - ]
5199
[Paper Exit After Staple End]
Enables or disables the paper feeding out from the finisher without stapling.
•
If this setting is "1: ON", paper is fed out without stapling at the maximum number of
the finisher stapling when the machine gets a multiple printing job (over maximum
number).
• If this setting is "0: OFF", paper is fed out with stapling at the maximum number of the
finisher stapling when the machine gets a multiple printing job (over maximum
number).
001 0: OFF 1: ON CTL
[ 0 or 1 / 0 / 1/step]
0: OFF
1: ON
SP5-009 to 721 (Mode)
227