Voids
Cause:
Steam from the paper can cause condensation on the guide plate between the fusing part and the heat
pipe roller.
The consequence of this phenomenon will vary depending on when the condensation appears on the
paper.
<If condensation appears after fusing>
It will cause wrinkling or irregular lines to form.
<If condensation appears before transferring>
Voids will appear.
This may occur if:
• When printing in low temperatures.
• When printing in high humidity (such as rainy days or days before/after rain).
• When storing paper in high humidity.
Solution:
Implement one of the following solutions:
• Store the paper using material that protects it from humidity.
• Store the paper in a low-humidity environment.
• Set the machine's anti-condensation heater switch to "ON".
• In [System Settings], set the [Weekly Timer Detailed Settings] to start the printer 30 minutes before
printing begins.
• Before printing, print 30 sheets of double-sided A3 paper, to remove the condensation.
7. Image Quality Problem: Full Page
116
To Next Page
Loading...
