• For details about Weekly Timer Detailed Settings, see "System Settings", Device Management.
Worm Holes: Text or Edge of an Image
Dropouts (character voids) occur when characters or lines are printed in color mode.
Cause:
This may occur if:
• Printing is done at high temperature or humidity
• Printing solid fills
• Slippery paper is used
• Printing on small size of paper
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
• Dropouts (character voids) do not occur on the first sheet.
Solution:
(a) Adjusting the image density
1. Launch Fiery Command WorkStation 6.
2. Click [Job Properties] corresponding to the image to be printed.
Unprinted
117
To Next Page
Loading...
