90 mm
(3.5 in.)
90 mm
(3.5 in.)
CEZ564
Cause:
This may occur if:
• Printing is done at low temperature or humidity
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
(a) Decreasing the transfer timing roller speed
1. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
and then check the present value in [Transfer Timing Roller]. Is it lower than -0.5%?
Yes Proceed to "(c) Increasing the transfer timing roller speed".
No Go to the next step.
2. Select 1341: [Motor Speed], and then decrease the value in [Transfer Timing Roller] by
0.1%.
3. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
7. Image Quality Problem: Full Page
130
To Next Page
Loading...
