4. Did changing the density make the problem worse?
Yes Set [Transfer Timing Roller] back to its original value, and then proceed to "(b)
When reducing the transfer timing roller value aggravates the problem".
No Go to the next step.
5. Select 1341: [Motor Speed], and then check the present value in the [Transfer Timing
Roller]. Is it lower than -0.5%?
Yes Contact your service representative.
No Go to the next step.
6. Select 1341: [Motor Speed], and then decrease the value in [Transfer Timing Roller] by
0.1%.
7. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 5 to 7.
(b) When reducing the transfer timing roller value aggravates the problem
1. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
and then check the present value in [Transfer Timing Roller]. Is it higher than 0.5%?
Yes Contact your service representative.
No Go to the next step.
2. Select 1341: [Motor Speed], and then increase the value in [Transfer Timing Roller] by
0.1%.
3. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 to 3.
(c) Increasing the transfer timing roller speed
1. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
and then set the value in [Transfer Timing Roller] to "-0.5%".
2. Print the image. Did changing the density make the problem worse?
Yes Contact your service representative.
Uneven Density
131
To Next Page
Loading...
