No Go to the next step.
3. Select 1341: [Motor Speed], and then check the present value in [Transfer Timing Roller].
Is it higher than 0.5%?
Yes Contact your service representative.
No Go to the next step.
4. Select 1341: [Motor Speed], and then increase the value in [Transfer Timing Roller] by
0.1%.
5. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 3 to 5.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
Uneven Density (Textured Paper)
White spots on an embossed surface
This is because the voltage of the applied paper transfer roller is too low.
Dense printing on an embossed surface
This is because the voltage of the applied paper transfer roller is too high.
7. Image Quality Problem: Full Page
132
To Next Page
Loading...
