Cause:
This may occur if:
• Heavily textured paper is used.
• Thick paper is used.
• Documents with a small image area are printed continuously.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
(a) Adjust the textured paper mode
1. In [Advanced Settings] for the custom paper you are using, select 1218: [Paper Transfer
Output: Textured Paper Mode], and then set [Setting] to [On].
2. Select 1231: [Print Speed], and then set the following corresponding settings to [Low].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
Uneven Density
133
To Next Page
Loading...
