[Side 1], [Side 2]
• [FCS]
[Side 1], [Side 2]
• [S]
[Side 1: Clear/Special], [Side 1: White]
[Side 2: Clear/Special], [Side 2: White]
3. Print the image. Has the problem been resolved?
Yes Finished!
No Go to next step.
4. In [Advanced Settings] for the custom paper you are using, select 1212: [Image Transfer
Output], and then adjust the value in the following corresponding settings by one step.
Adjust the value within ±10 steps from the current value.
• [BW]
[Black]
• [FC/FCS]
[Black], [Cyan], [Magenta], [Yellow], [Clear/Special], [White]
• [S]
[Clear/Special], [White]
5. Print the image. Has the problem been resolved?
Yes Finished!
No Go to next step.
6. In [Advanced Settings] for the custom paper you are using, set 1218: [Paper Transfer
Output: Textured Paper Mode] to [On].
7. Select 1231: [Print Speed], and then set the following corresponding settings to [Low].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
7. Image Quality Problem: Full Page
142
To Next Page
Loading...
