Ricoh PRO C7210

• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
8. Print the image. Has the problem been resolved?
Yes Finished!
No Go to next step.
9. In [Advanced Settings] for the custom paper you are using, select 1218: [Paper Transfer
Output: Textured Paper Mode], and then adjust the value in the following corresponding
settings by one step.
Adjust the value within ±10 steps from the current value.
• [BW]
[Side 1], [Side 2]
• [FC/FCS]
[Side 1], [Side 2]
• [FCS]
[Side 1], [Side 2]
• [S]
[Side 1: Clear/Special], [Side 1: White]
[Side 2: Clear/Special], [Side 2: White]
10. Print the image. Has the problem been resolved?
Yes Finished!
No Go to next step.
11. Select 1214: [Paper Transfer Output], and then adjust the value in the following
corresponding settings by 1 step.
Adjust the value within ±10 steps from the current value.
• [BW]
[Side 1], [Side 2]
• [FC/FCS]
[Side 1], [Side 2]
• [FCS]
[Side 1], [Side 2]
Uneven Density
143