• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
2. Print 5 or more A4 sheets. Has the problem been resolved?
Yes Go to the next step.
No Repeat Steps 1 and 2.
3. Is the toner fusibility within the permissible range?
Yes Finished!
No Contact your service representative.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
• Check the toner fusibility as follows:
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if it is rubbed by the cloth for cleaning the contact glass.
Blurred Image: Around a Clear Image
Blurring occurs around a clear image.
Normal
Uneven Density
149
To Next Page
Loading...
