Blurred
Cause:
This may occur if:
• Printing in a high temperature and humidity environment
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
1. In [Advanced Settings] for the custom paper you are using, select 1212: [Image Transfer
Output], and then decrease the value in [Black] of [FC/FCS] by 1.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 to 2. If the problem persists even if you lower the value to -10,
contact your service representative.
• Reducing the 1212: [Image Transfer Output] [Black] value may reduce the black density.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
7. Image Quality Problem: Full Page
150
To Next Page
Loading...
