Ricoh PRO C7210

No Proceed to "(b) Decreasing the image transfer output".
3. Select 1212: [Image Transfer Output], and then increase the value in the following
corresponding settings.
• [BW]
[Black]
• [FC/FCS]
[Black]
4. Print the image. Has the problem been resolved?
Yes Go to the next step.
No Repeat Step 1 to 4.
5. Does any of the following problems occur?
• Drum imprint
• A black image is faint.
• Edge of an image is faint.
Yes Go to the next step.
No Finished!
6. Select 1212: [Image Transfer Output], and then decrease the value in the following
corresponding settings until the problem is reduced sufficiently.
• [BW]
[Black]
• [FC/FCS]
[Black]
7. Proceed to "(c) Adjusting the maximum image density".
(b) Decreasing the image transfer output
1. Does any of the following problems occur?
• Drum imprint
• A black image is faint.
• Edge of an image is faint.
Yes Go to the next step.
No Proceed to "(c) Adjusting the maximum image density".
7. Image Quality Problem: Full Page
178