2. In [Advanced Settings] for the custom paper you are using, select 1212: [Image Transfer
Output], and then decrease the value in the following corresponding settings until the
problem is reduced sufficiently.
• [BW]
[Black]
• [FC/FCS]
[Black]
3. Proceed to "(c) Adjusting the maximum image density".
(c) Adjusting the maximum image density
1. In [Advanced Settings] for the custom paper you are using, select 1201: [Max Image
Density], and then decrease the value in [Black].
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. Is [Black] in 1201: [Max Image Density] set to -5?
Yes Contact your service representative.
No Repeat Steps 1 to 3.
(d) When toner appears on the leading edge of the paper
1. In [Advanced Settings] for the custom paper you are using, select 1101: [Image Position],
and then increase the value in the following corresponding settings.
When making adjustments in the plus direction, the leading edge will increase according to the
value set, and the trailing edge will correspondingly decrease.
• [Image Position: Side 1]
[With Feed]
• [Image Position: Side 2]
[With Feed]
(e) Adjusting the paper transfer pressure
1. In [Advanced Settings] for the custom paper you are using, set the value in 1222: [Paper
Transfer Nip Operation Mode] to [Low Pressure Mode].
Dirtied Printouts
179
To Next Page
Loading...
