Ricoh PRO C7210

• [S: Fuser Setting HQ]
[Corct Temp: Pre-Fd: Clr/Sp], [Corct Temp: Pre-Fd: White]
4. Print the image and check toner fusion. Has the problem been resolved?
Yes Finished!
No Go to the next step.
5. Is 1231: [Print Speed] set to [Middle]?
Yes Set 1231: [Print Speed] to [Low].
No If the problem persists, contact your service representative.
6. In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then set the value in the following corresponding settings by 10.
• [BW/FC/FCS]
[Corct Temp: Pre-Feed]
• [FCS]
[Corct Temp: Pre-Fd: Clr/Sp], [Corct Temp: Pre-Fd: White]
• [S]
[Corct Temp: Pre-Fd: Clr/Sp], [Corct Temp: Pre-Fd: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Corct Temp: Pre-Feed]
• [FCS: Fuser Setting HQ]
[Corct Temp: Pre-Fd: Clr/Sp], [Corct Temp: Pre-Fd: White]
• [S: Fuser Setting HQ]
[Corct Temp: Pre-Fd: Clr/Sp], [Corct Temp: Pre-Fd: White]
7. Print the image and check toner fusion. Has the problem been resolved?
Yes Finished!
No If the problem persists, contact your service representative.
• If you change the value of 1231: [Print Speed] from [Low] to [High] or to [Middle], in 1232:
[Fusing Temperature], reset the value of [Corct Temp: Pre-Feed] to its default value.
• Changing the fusing temperature or changing the process speed may produce one or more of the
following side effects:
3. Specifying and Checking Paper Settings
24