6. Select [Magazine].
7. Press [OK].
8. Press [Edit / Color].
9. Press [Margin Adj.].
10. Specify left margin on the front side to 5 mm and right margin on the back side to 5 mm.
Paper Edges Are Stained
Cause:
While back curls are removed, the toner adhesion becomes insufficient when the fusing pressure roller is
used on the paper, allowing the toner to stain the anti-static brush.
This may occur if:
• The decurler unit is attached.
• Paper needs to be curled backward.
• Sheets are delivered with their printed side facing up in the post-processing machine.
Solution:
1. In the [Machine: Paper Feed/ Output] group of the [Adjustment Settings for Operators]
menu, set 0304: [Correct Output Paper Curl] to "U Curl Correction Level".
If "Off" is selected, change the value to "Small". If "Small" is selected, change the value to "Large".
2. If you cannot remove back curls, print with the printed side face up for single-sided
printing.
Finisher
287
To Next Page
Loading...
