Ricoh PRO C7210

Multi-Folding Unit
Inaccurate Folding (Folding Deviation)
Cause:
Depending on paper hardness, inaccurate folds may result. This is referred to as folding deviation.
Solution:
Change the folding position by adjusting the position of the paper edge stopper for folding.
For multi-sheet folding, change the folding position using the following settings in the [Finishing: Fold]
group on the [Adjustment Settings for Operators] menu:
• 0701: [Z-fold Position 1]
• 0702: [Z-fold Position 2]
• 0703: [Half Fold Position: 1 sheet Fold]
• 0704: [Half Fold Position: Multi-sheet Fold]
• 0705: [Letter Fold-out Position 1: 1 sheet Fold]
• 0706: [Letter Fold-out Position 1: Multi-sheet Fold]
• 0707: [Letter Fold-out Position 2: 1 sheet Fold]
• 0708: [Letter Fold-out Position 2: Multi-sheet Fold]
• 0709: [Letter Fold-in Position 1: 1 sheet Fold]
• 0710: [Letter Fold-in Position 1: Multi-sheet Fold]
• 0711: [Letter Fold-in Position 2: 1 sheet Fold]
• 0712: [Letter Fold-in Position 2: Multi-sheet Fold]
• 0713: [Double Parallel Fold Position 1]
• 0714: [Double Parallel Fold Position 2]
• 0715: [Gate Fold Position 1]
• 0716: [Gate Fold Position 2]
• 0717: [Gate Fold Position 3]
9. Post-Processing Option Troubleshooting
288