Solutions:
1. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
and then check the present value in [Paper Transfer Roller]. Is it lower than 0.5%?
Yes Increase the value in [Paper Transfer Roller] by 0.1%.
No No further improvement is likely. Contact your service representative.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1and 2.
Horizontal Streaky Density Fluctuation: Trailing Edge of Paper (85 mm)
When printing on metallic or black paper, white streaks appear in the area approximately 85 mm from
the trailing edge of the paper.
Cause:
This may occur when printing on low-resistance metallic or black paper.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
5. Image Quality Problem: Lines
80
To Next Page
Loading...
