Solutions:
1. In [Advanced Settings] for the custom paper you are using, select 1214: [Paper Transfer
Output], and then adjust the values in the following settings in steps of ±1 according to the
mode in use.
• [BW]
[Side 1], [Side 2]
• [FC/FCS]
[Side 1], [Side 2]
• [FCS]
[Side 1], [Side 2]
• [S]
[Side 1: Clear/Special], [Side 1: White]
[Side 2: Clear/Special], [Side 2: White]
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Step 1 to 2.
If the density becomes too low or white spots appear, contact your service
representative.
Horizontal Streaks: Synthetic Paper
When printing on synthetic paper, multiple white streaks appear perpendicular to the paper feed
direction.
Bands
81
To Next Page
Loading...
