Cause:
This may occur when printing on high-resistance synthetic paper.
This may occur if:
• Printing is done at low temperature or humidity
• Halftone images are printed
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solutions:
1. In [Advanced Settings] for the custom paper you are using, select 1214: [Paper Transfer
Output], and then adjust the values in the following settings in steps of ±1 according to the
mode in use.
• [BW]
[Side 1], [Side 2]
• [FC/FCS]
[Side 1], [Side 2]
• [FCS]
[Side 1], [Side 2]
• [S]
[Side 1: Clear/Special], [Side 1: White]
[Side 2: Clear/Special], [Side 2: White]
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Step 1 to 2.
If the density becomes too low or white spots appear, contact your service
representative.
5. Image Quality Problem: Lines
82
To Next Page
Loading...
