3. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 to 3.
• If you reduce the paper transfer output to eliminate white spots, copies may become too faint.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
• The problem may be reduced by performing the solution specified in page 25 "Improving
Transferability".
Blister-like White Spots
White spots 0.3–0.5 mm (0.01–0.02 inches) in diameter surrounded by denser spots (blister-like white
spots) appear.
Cause:
This may occur if a solid image is printed on coated paper, if a solid image is printed during duplex
printing, or if printing is done at low temperature.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
6. Image Quality Problem: Spots
94
To Next Page
Loading...
