Solution:
Carry out the following sequence of procedures. Terminate the sequence as soon as the problem is
resolved.
(a) Changing the print setting
1. In the printer driver screen of Fiery Command WorkStation 6, set Fuser Setting HQ mode.
2. Print 10 or more A3 sheets. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. Decrease the print speed. This will decrease the throughput, but is it OK?
Yes Proceed to "(b) Changing the printing speed".
No Proceed to "(e) Decreasing the fusing temperature".
(b) Changing the printing speed
1. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then decrease the value in the following corresponding settings by one level.
If the present value is [High], select [Middle]. If it is [Middle], select [Low].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
2. Is the setting set to [Middle]?
Yes Proceed to "(c) Changing the fusing temperature (If [Print Speed] is set to
[Middle])".
Spots
95
To Next Page
Loading...
