3. Click the [Color] tab.
4. Click [General Settings] or [Expert Settings].
5. Check the setting value in "Gray and Black (CMYK and RGB)". Is it "ColorWise Off"?
Yes Go to the next step.
No Proceed to Step 7.
6. Ensure that "Gray and Black (CMYK and RGB)" is not set to [ColorWise Off].
When printing a highly dense image or one that requires a large amount of toner, in the [Job
Properties] [Image] tab, select [Toner Reduction].
7. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
8. In the [Machine: Image Quality] group on the [Adjustment Settings for Operators] menu,
select 0201: [Execute Image Quality Adjustment] and execute [Adjust Image Density].
9. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
10. Adjust the image density.
<If custom paper is used>
In [Advanced Settings] for the custom paper you are using, select 1201: [Max Image
Density], and then change all color values to [ ].
<If custom paper is not used>
In the [Machine: Image Quality] group on the [Adjustment Settings for Operators] menu,
select 0202: [Maximum Image Density], and then change all color values to [ ].
11. Print the image. Has the problem been resolved?
Yes Finished!
No Proceed to "(b) Adjusting the paper transfer feed pressure" or "(c) Adjusting the
paper transfer speed".
(b) Adjusting the paper transfer feed pressure
1. Register the paper in the custom paper profile.
7. Image Quality Problem: Full Page
118
To Next Page
Loading...
