2. In [Advanced Settings] for the custom paper you are using, set the value in 1222: [Paper
Transfer Nip Operation Mode] to [Low Pressure Mode].
3. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
4. Select 1223: [Paper Transfer Nip], and then set [Adjust Gap] to "4".
5. Print the image. Has the problem been resolved?
Yes Finished!
No Proceed to "(c) Adjusting the paper transfer speed" or "(d) Adjusting the
environment".
(c) Adjusting the paper transfer speed
1. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
decrease the value in [Transfer Timing Roller] by 0.1%.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 and 2. If the problem persists even if you decrease the value to
-0.5, proceed to "(b) Adjusting the paper transfer feed pressure" or "(d) Adjusting
the environment".
(d) Adjusting the environment
Perform the following solution within the permissible range:
• Lower the temperature and humidity.
• Change to non-slippery paper.
If the problem persists, contact your service representative
• Lowering the maximum image density may affect the hues of the image.
• Adjusting the pressure for the paper transfer may cause a rough image or jitter to occur.
• Lowering the roller value for the paper transfer may shrink the subscan-directional image. If this
occurs, select 1101: [Image Position], and then set the following values to [ ].
• [With Feed] of [Image Magnification: Side 1]
• [With Feed] of [Image Magnification: Side 2]
• Decreasing the process speed may produce either or both of the following side effects:
Unprinted
119
To Next Page
Loading...
