Ricoh PRO C7210X

• A solid image is printed
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
1. In the [Machine: Productivity] group on the [Adjustment Settings for Operators] menu,
select 0404: [Pressure Roller Cooling Fan Level], and then set the value in the following
settings to [Strong].
• [Press Cool Fan Lvl: Pre-Fd]
• [Press Cool Fan Lvl: Aft-Fd]
• [Press Cool Fan Lvl: Stndby]
2. Select 0403: [Fusing Temperature on Standby], and then set the value in the following
settings to "50".
• [Press Rlr: On Standby]
• [Press Rlr: On Panel Off]
• [Press Rlr: On Low Power]
• [Press Rlr: Before Process]
3. In the printer driver screen of Fiery Command WorkStation 6, set Fuser Setting HQ mode.
4. In [Advanced Settings] for the custom paper you are using, select 1236: [Fusing Pressure
Roller Cooling], and then set the value in the following corresponding settings to "0".
• [BW/FC/FCS]
[Fan Level: BW/FC/FCS]
• [FCS/S]
[Fan Level: Clear/Special], [Fan Level: White]
5. Select 1233: [Fusing Pressure Temperature], and then set the value in the following
corresponding settings to "50".
• [BW/FC/FCS]
[Press Rlr Temp: BW/FC/FCS]
• [FCS/S]
[Press Rlr Temp: Clr/Sp], [Press Rlr Temp: White]
6. Print 3 or more A3 sheets. Has the problem been resolved?
Yes Finished!
Uneven Density
167