Ricoh PRO C7210X

No Go to the next step.
7. Decrease the line speed. This will decrease the throughput, but is it OK?
Yes Proceed to "(a) Decreasing the printing speed".
No Proceed to "(b) Decreasing the fusing temperature".
(a) Decreasing the printing speed
1. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then set the value in the following corresponding settings to [Low].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
2. Select 1232: [Fusing Temperature], and then decrease the value in the following
corresponding settings by 20°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
7. Image Quality Problem: Full Page
168