Ricoh PRO C7210X

Solutions:
1. In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then increase the value in the following corresponding settings by
5°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
2. Print 10 or more sheets. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 and 2. If the problem persists even if you lower the value to 185°C,
go to the next step.
3. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then check the present value in the following corresponding settings.
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
Dirtied Printouts
189